ENGO blister patches minimise the shearing forces between the bone, muscle, fat and the upper layers of the skin by reducing the coefficient of friction by up to 80% at the shoe-sock interface.
What are ENGO® patches?
ENGO® blister prevention patches are patented low-friction patches manufactured with pressure-sensitive adhesive.
Unlike other blister prevention and relief patches, ENGO® patches are applied to the inside of footwear, to the surfaces of insoles, or to socks – NOT TO THE SKIN. This means the patches provide long-lasting protection from blisters and are pain-free to apply and remove. ENGO® patches are thin, sweat-proof and latex-free!
How to apply the blister prevention patch
Select the size of the patch based on the area of coverage required and ensure that your footwear is dry. Tip: Select a patch that is around one centimetre larger than the area where you know you get blisters or where you are getting a "hot spot".
Using the easy-peel tab, partially peel away the white backing to give you an area to hold whilst handling the patch.
Apply the sticky side of the patch to the desired area of dry footwear.
Peel the remaining backing away and press the patch firmly onto the area.
Press firmly around the entire patch surface to secure it.
ENGO’s adhesive is pressure-sensitive. Therefore, as the pressure on the patch increases so does patch adhesion to the shoe. The patches will eventually need replacement once the blue top layer wears through, or completely releases from, the white support layer.
Examples of the type of patch to use
Some examples of the type of patch to use in different areas are:
Large oval: Useful for large areas on the inside of footwear that rub on the heel, ball of the foot, arch and side of the foot.
Small oval: Suitable for small areas on the inside of footwear that rub against the heel or the toes.
How to remove the blister prevention patch
To remove a worn-out ENGO® patch, simply pull from the edge and it will peel off. Make sure you replace it with a new patch to ensure continued protection against blisters. If you have a problem removing a patch you can warm it very slightly using a safe heat source such as a hair dryer to loosen the adhesive.
Other uses for the ENGO® patches
You can apply ENGO® blister patches wherever you normally experience blisters or soreness caused by the rubbing of your skin.
All sports footwear
Normal shoes
Walking and Hiking boots
Breaking in new footwear and boots
Ice-skates
Insoles
Oars, blades and paddles
Ski poles
Rake, Hoe and Shovel handles
Braces and pads
Under the clasp at the back of a bra
You can even use ENGO® patches on the bottom of furniture feet to make it easier to move around. If you find any other uses we have not mentioned, let us know by email and we'll send you a few free patches.
